Clopay Torsion Spring Replacement Nationwide

Clopay Torsion Spring Replacement: The West Palm Beach Owner’s Guide

Clopay torsion spring replacement in West Palm Beach typically runs $180 to $340 installed, and we carry Clopay-compatible springs on the truck for same-day replacement in most cases. The torsion spring is the big coil mounted on the metal bar above your garage door that does the heavy lifting every time the door goes up and down. When it fails, you’ll know: the garage door won’t lift, or one side hangs lower than the other, or you hear a bang from the garage that sounds like a firecracker. That sound is the spring snapping clean through, and it’s the most common way our West Palm Beach customers discover they need us.

Call (728) 220-0705

You’re not stuck. We stock the spring sizes that fit the majority of Clopay doors in South Florida, which means we can usually get your door working again on the first visit. And since every West Palm Beach quote is written down and handed to you before we touch a bolt, there’s no surprise on the invoice. Aaron Teague has built Doyle Garage Doors West Palm Beach on exactly that: showing up when we say we will and handing you a price before the work starts.

Which Clopay Models This Applies To

If your garage door says Clopay on it, the torsion spring we install is matched to your door’s weight and height, not just the brand name. Clopay makes doors in a wide range: the entry-level Classic series, the mid-grade Gallery, the premium Coachman and Reserve lines with their wood-look steel, and the older Intellicore models still on thousands of West Palm Beach garages. Each line has different panel weights, which means different spring requirements.

The spring itself is selected by wire size, inside diameter, and length. Those numbers have to match what the door weighs. A Clopay 16×7 non-insulated door needs a different spring than a 16×7 Intellicore with a layer of polyurethane foam inside it. That’s the compatibility gotcha that catches a lot of people: two doors that look identical from the street can call for completely different springs. A good tech measures and weighs before quoting. A bad tech guesses. We measure.

On the question of OEM versus aftermarket: Clopay sells replacement springs through its dealer network, but quality aftermarket equivalents from the same American spring manufacturers are available. We install both. What matters is that the spring is rated for the correct cycle life, typically 10,000 or 20,000 cycles for residential doors. That’s the spec that determines how long the spring lasts in Florida heat and humidity. We’ll tell you which rating we’re quoting and why.

Signs Your Clopay Torsion Spring Is Failing

• The door won’t open, or opens only a few inches and stops. The spring provides the lifting force, so when it breaks, the opener motor strains against the full weight of the door. That’s the motor you’re hearing grind when you press the button.
• A loud bang or snap from the garage. That’s the spring breaking under tension. It’s alarming, but it’s normal for a spring to fail that way after several years. It doesn’t mean your door is ruined.
• The door feels extremely heavy when you try to lift it manually. With the emergency release pulled, a balanced door should lift with one hand. If it feels like dead weight, the spring has lost its strength or broken entirely.
• One side of the door sits higher than the other when closed. A weakening spring on one side changes the balance point and the door starts to lean. Left unfixed, this wears out cables and hinges on the low side.
• Visible gap in the spring coil above the door. Walk to the center of the garage, look up at the metal bar across the top, and check the coil. If you see a clean break with the coil separated into two pieces, that’s the failure. Only one spring on a two-spring door may have snapped, but the other is likely close behind.

Replacement Cost & What’s Included

Our installed price for Clopay torsion spring replacement in West Palm Beach runs $180 to $340, depending on spring size, cycle rating, and whether we’re replacing one spring or a pair. That price includes the spring, the labor to remove the old one and install the new one, rebalancing the door, and lubricating the moving parts while we’re up there. The price is written down and agreed to before any work starts. What we quote is what you pay.

Here’s how the pricing breaks down:

• Single spring replacement: $180 to $270, installed.
• Both springs (recommended for two-spring doors): $250 to $340, installed.
• Higher-cycle spring upgrade (20,000 vs 10,000 cycles): adds $30 to $60 per spring.

Every Clopay spring replacement from Doyle Garage Doors West Palm Beach carries our 365-Day Done Right Promise. If the spring fails within 365 days, we come back and replace it at no charge. No forms, no arguments, no “pro-rated” fine print. That’s the guarantee, in writing, on every single spring job we do.

DIY or Call Us?

Here’s the honest answer: this is the one repair we tell homeowners to leave alone. A torsion spring holds hundreds of pounds of torque even at rest. The winding bars, the set screws, the unwinding process: one wrong move and that stored force releases into whatever is in the way, which is usually your hands or face. Even experienced techs treat a wound spring with respect. This isn’t like swapping a light fixture. The risk is real and the injury is permanent.

What you can safely do: check the spring visually for a break (from the ground, with the door closed), test the door’s balance by pulling the emergency release and lifting it a foot or two, and take note of any noises or jerky movement. That’s useful information to give us on the phone. Then call (728) 220-0705. Our tech will arrive with the right springs on the truck, a name and photo already texted to your phone before they show up, and a background check on file. You’ll know who’s walking up your driveway before they ever ring the bell.

FAQs